Kuat Tekan dan Penyerapan Batako Menggunakan Serat Pelepah Kelapa

Darul Niham Wahono(1*), Zaenuri Arifin(2), Yosef Cahyo Setianto Poernomo(3), Zendy Bima Mahardana(4), Ashabul Yamin(5),

(1) Faculty of Engineering, Kadiri University
(2) Faculty of Engineering, Kadiri University
(3) Faculty of Engineering, Kadiri University
(4) Faculty of Engineering, Kadiri University
(5) Faculty of Engineering, Kadiri University
(*) Corresponding Author

Abstract


Brick is a building material that has a function as a room sealer. Its larger size, when compared to red brick, makes bricks more in demand in the market. Improving the quality of bricks needs to be done to meet the needs of the building. The use of added materials becomes one of the things that can be considered to improve the nature and quality of bricks. This research aims to find out the strong press and absorption of bricks with the use of coconut pellet fiber. The research was conducted experimentally with the manufacture of test objects in the laboratory. The test object used is in the form of a beam of 30x15x10 cm. The percentage variation of coconut fiber is 5%, 10%, and 15% of the weight mass in bricks. The tests carried out include a strong compressive and water absorption test with reference to the Indonesian National Standard (SNI). The results of water absorption tests obtained the optimum value in bricks with a mixture of 5% fiber which is 6% of the mass of the weight of the brick, while the minimum value is in the brick, 15% fiber, which is 10%. While the compressive strength results get the optimum value on the 5% fiber mix variation, which is 20.1 kg/cm², and the minimum value on the variation of 15% fiber is 8.8 kg/cm². From these results showed that bricks with coconut pellet fiber have not been able to improve the quality of bricks.

Keywords


Absorption; Coconut Fiber Midrib; Compressive Strength; Concrete Brick

Full Text:

PDF Similarity

References


S. D. Hartantyo and M. H. Susianto, “Pengaruh Penambahan Tumbukan Cangkang Keong Mas Terhadap Kuat Tekan Beton Non Struktual K-175,” UKaRsT, vol. 3, no. 2, p. 7, 2019, doi: 10.30737/ukarst.v3i2.476.

R. O. Musyakti, “Pengaruh Penggantian Agregat Halus Dengan Limbah Ban Karet Terhadap Berat Isi, Kuat Tekan Dan Serapan Air Pada Batako,” Digilib UNS, 2019.

Nurzal, M. Perdana, and H. P. Putera, “The effect of fly ash composition and drying time concrete brick in density test,” MATEC Web Conf., vol. 215, pp. 26–29, 2018, doi: 10.1051/matecconf/201821501029.

R. Sinaga, “Penambahan Ijuk Sebagai Bahan Pengisi Pembuatan Batako Ringan,” Univ. Medan Area, 2018.

O. Gencel, E. Erdugmus, M. Sutcu, and O. H. Oren, “Effects of concrete waste on characteristics of structural fired clay bricks,” Constr. Build. Mater., vol. 255, p. 119362, 2020, doi: 10.1016/j.conbuildmat.2020.119362.

A. Y. Z, E. Maulanie, and M. S. LukmanP, “Pemanfaatan Limbah Sludge Kertas Pt . Adiprima Suraprinta Pada Pembuatan Panel Dinding,” Tek. Sipil, vol. 9, no. 978, pp. 113–120, 2011.

S. Sumarni and W. Wijanarko, “Preparation and Mechanical Properties of Pressed Straw Concrete Brick,” IOP Conf. Ser. Mater. Sci. Eng., vol. 333, no. 1, 2018, doi: 10.1088/1757-899X/333/1/012098.

X. Yuan, Y. Tang, Y. Li, Q. Wang, J. Zuo, and Z. Song, “Environmental and economic impacts assessment of concrete pavement brick and permeable brick production process - A case study in China,” J. Clean. Prod., vol. 171, pp. 198–208, 2018, doi: 10.1016/j.jclepro.2017.10.037.

A. Syafi’urroziq, Y. C. S. Purnomo, and L. D. Krisnawati, “Pemanfaatan Serbuk Kaca dari Jenis Kaca Bening dengan Ketebalan 3-4 mm Sebagai Bahan Tambah dalam Pembuatan Batako,” J. Manaj. Teknol. Tek. Sipil, vol. 1, no. 1, pp. 44–55, 2018, doi: 10.30737/jurmateks.v1i1.139.

C. Prasetya, A. Rahman, and R. Y. Efranto, “Analisa Desain Eksperimen Pembuatan Batako Berbahan Alternatif Lumpur Lapindo Dan Fly Ash Dengan Metode Taguchi,” J. Rekayasa Dan Manaj. Sist. Ind., vol. 1, no. 1, pp. 57–65, 2017.

M. Y. Nurain Izzati et al., “Strength and water absorption properties of lightweight concrete brick,” IOP Conf. Ser. Mater. Sci. Eng., vol. 513, no. 1, 2019, doi: 10.1088/1757-899X/513/1/012005.

M. A. B. Emon, T. Manzur, and N. Yazdani, “Improving performance of light weight concrete with brick chips using low cost steel wire fiber,” Constr. Build. Mater., vol. 106, pp. 575–583, 2016, doi: 10.1016/j.conbuildmat.2015.12.165.

D. Maia de Souza et al., “Comparative life cycle assessment of ceramic brick, concrete brick and cast-in-place reinforced concrete exterior walls,” J. Clean. Prod., vol. 137, pp. 70–82, 2016, doi: 10.1016/j.jclepro.2016.07.069.

D. H. Prayogo, A. Ridwan, and S. Winarto, “Pemanfaatan Limbah Gypsum Board Dan Batu Bata Merah Untuk Substitusi Semen Pada Pembuatan Beton,” J. Manaj. Teknol. Tek. Sipil, vol. 2, no. 2, p. 333, 2019, doi: 10.30737/jurmateks.v2i2.542.

N. A. Affandy and A. I. Bukhori, “Pengaruh Penambahan Abu Serabut Kelapa Terhadap Kuat Tekan Beton,” UKaRsT, vol. 3, no. 2, pp. 65–72, 2019.

D. Darwis, A. Astriana, and M. S. Ulum, “Pemanfaatan Limbah Serat Batang Sagu Untuk Pembuatan Batako,” Gravitasi, vol. 15, no. 1, pp. 1–9, 2017.

A. Gunarto, “Penelitian Campuran Aspal Beton Dengan Menggunakan Filler Bunga Pinus,” UKaRsT, vol. 3, no. 1, p. 37, 2019, doi: 10.30737/ukarst.v3i1.351.

S. F. Ahmadi and M. Reisi, “Comparison of mechanical and durability properties of concrete and fired facing bricks,” Proc. Inst. Civ. Eng. Struct. Build., vol. 173, no. 7, pp. 512–522, 2020, doi: 10.1680/jstbu.18.00144.

S. Salamah and Maryudi, “Utilization of Kelut’s volcanic ash as the aggregate mixture of concrete brick,” Key Eng. Mater., vol. 718, pp. 196–200, 2017, doi: 10.4028/www.scientific.net/KEM.718.196.

S. Febby Romaadhoni, A. Ridwan, S. Winarto, and A. I. Candra, “Studi Experimen Kuat Tekan Beton Dengan Memanfaatkan Limbah Keramik Dan Bata Merah,” J. Manaj. Teknol. Tek. Sipil, vol. 2, no. 1, p. 86, 2019, doi: 10.30737/jurmateks.v2i1.394.

F. Supriani and M. Islam, “Pengaruh Metode Perlakuan Dalam Perawatan Beton Terhadap Kuat Tekan Dan Durabilitas Beton,” Inersia, J. Tek. Sipil, vol. 9, no. 2, pp. 47–54, 2019, doi: 10.33369/ijts.9.2.47-54.

Wulandari, Kartisyah, and D. Kartikasari, “Studi Pencampuran Serat Eceng Gondok Pada Campuran Beton Dengan Penggunaan Agregat Kasar Dari Kecamatan Mantup,” UKaRsT, vol. 3, no. 1, pp. 18–27, 2019.

K. D. Kurniawan, A. Ridwan, and Y. Cahyo, “Uji Kuat Tekan Dan Arbsorpsi Pada Beton Ringan Dengan Penambahan Limbah Bata Ringan Dan Bubuk Talek,” J. Manaj. Teknol. Tek. Sipil, vol. 3, no. 1, p. 1, 2020, doi: 10.30737/jurmateks.v3i1.872.

Badan Standardisasi Nasional, “SNI 03-0349-1989 Bata beton untuk pasangan dinding,” SNI, 1989.

H. Maizir, R. Suryanita, and R. Arditama, “Study on performance of lightweight concrete bricks with a ratio of sand and cement composition,” IOP Conf. Ser. Mater. Sci. Eng., vol. 615, no. 1, 2019, doi: 10.1088/1757-899X/615/1/012105.




DOI: http://dx.doi.org/10.30737/jurmateks.v4i2.2016

Article Metrics

Abstract view : 472 times
PDF - 120 times Similarity - 25 times

Refbacks

  • There are currently no refbacks.


Email : jurmateks@unik-kediri.ac.id

Lisensi Creative Commons
Jurnal Manajemen Teknologi dan Teknik Sipil (JURMATEKS) is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.